The December winner is Dave, of West Glacier, Montana. Congratulations, Dave! You will enjoy using this rabbeting set in your projects:
To register for future drawings, send me an e-mail to sandal_woods@bbwi.net with your name and full address; I can no longer accept your entry if it does not have all the information. And please remember that if you have registered for the monthly drawings before, you do not have to register again.
Good luck to everyone! And a big thanks to Sommerfeld Tools for sponsoring this monthly drawing.
.
About Al Navas
Al…….I went over to see what the length of the cutting edge was. With a single length, the rabbeting set would not have worked, however the winged cutter set would have with so many options. My slot cutter has one edge and 3 bearings, no combination worked for mt application. Funny how you purchase tooling, then stop looking. I knew there was a tooling solution, just didn’t know where.
Hi, Neil. You are right – this is a *very* handy set to have in the shop. For the deepest rabbets I simply adjust the router table fence and make incremental cuts, until I reach the bearing depth. Pretty cool!
Hey Al……..I have to tell you. This rabbeting set could be very handy. I was looking to do an operation with my slot cutter which has 3 different sized bearings but I still could not get the depth of cut I wanted. Of course its done now, but this bit set may have worked better.