Comments on: A simple stop for the fence on the router table http://sandal-woodsblog.com/2009/06/07/a-simple-stop-for-the-fence-on-the-router-table/ Woodworking with passion - The woodworking blog and podcast of Al Navas Thu, 01 Dec 2011 23:29:11 +0000 hourly 1 http://wordpress.org/?v=3.2.1 By: Al Navas (Sandal Woods)http://sandal-woodsblog.com/2009/06/07/a-simple-stop-for-the-fence-on-the-router-table/comment-page-1/#comment-2354 Al Navas (Sandal Woods) Tue, 09 Jun 2009 15:26:53 +0000 http://sandal-woodsblog.com/?p=3206#comment-2354 Thanks, Shannon! You are right - this router bit can be a little bit of a challenge to set up. In the near future I will publish an article about how to simplify its use, using a nifty little jig. Thanks, Shannon!
You are right – this router bit can be a little bit of a challenge to set up. In the near future I will publish an article about how to simplify its use, using a nifty little jig.

]]> By: Shannonhttp://sandal-woodsblog.com/2009/06/07/a-simple-stop-for-the-fence-on-the-router-table/comment-page-1/#comment-2353 Shannon Tue, 09 Jun 2009 14:59:44 +0000 http://sandal-woodsblog.com/?p=3206#comment-2353 Al, Great post and what a great bit. This is the first "complex" bit I bought and have used it the same way you did to make quarter sawn columns many times. One tip for your readers. This bit takes some fiddling to get just right so once you do get it set, make a setup block out of scrap and label it for future use. Shannon Al,

Great post and what a great bit. This is the first “complex” bit I bought and have used it the same way you did to make quarter sawn columns many times. One tip for your readers. This bit takes some fiddling to get just right so once you do get it set, make a setup block out of scrap and label it for future use.

Shannon

]]>